Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 287

peer-secondary-dns-address IP address to be used in negotiation of
the peer secondary DNS address
peer-primary-wins-address IP address to be used in negotiation of the
peer primary WINS address
peer-secondary-wins-address IP address to be used in negotiation of
the peer secondary WINS address
NOTE: The command displays the authentication status as "none" for any parameters
not provided by the authentication server.
peer-ipv6–interface-id IPv6 interface Identifier of the peer returned in
an authentication grant from the RADIUS server
Authentication statistics Shows statistics accumulated since the session
was established
up-time Time the session has been up, in seconds
in-octets Number of octets received on the interface
out-octets Number of octets transmitted out the interface
in-packets Number of packets received on the interface
out-packets Number of packets transmitted out the interface
PAP protocol configuration
request-timeout Maximum time, in seconds, to wait for an
authentication request packet
CHAP protocol configuration
name Name to be used in challenge packets
challenge-retry Maximum number of challenge packets to be
transmitted
challenge-timeout Frequency, in seconds, of challenge packet
retransmission
minimum-challenge-length Minimum length of challenge packet
maximum-challenge-length Maximum length of challenge packet; the
size of the challenge used for each challenge packet is a random number
between minimum-challenge-length and maximum-challenge-length
minimum-rechallenge-timeout Minimum time, in seconds, before
initiating a rechallenge to peer
maximum-rechallenge-timeout Maximum time, in seconds, before
initiating a rechallenge to peer; the actual time before a rechallenge is
a random number between minimum-rechallenge-timeout and
maximum-rechallenge-timeout
Chapter 7: Configuring Point-to-Point Protocol
Monitoring PPP Interfaces
257