Creating Vc Subranges That Include Static Atm Interfaces - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual
For e series broadband services routers - link layer configuration
Hide thumbs
Also See for JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010:
- Configuration manual (788 pages)
Table of Contents
Advertisement
Creating VC Subranges That Include Static ATM Interfaces
You can configure a bulk-configured VC subrange that includes the VPI and VCI
addresses belonging to an existing ATM PVC on a static ATM interface. This example
is essentially the reverse of the procedure in "Creating Static ATM Interfaces Within
VC Subranges" on page 606.
To create a VC subrange that includes a static ATM interface:
1.
2.
3.
4.
atm bulk-config
atm pvc
Chapter 16: Configuring Dynamic Interfaces Using Bulk Configuration
Specify a static ATM 1483 subinterface.
host1(config-if)#interface atm 3/1.201
Configure an ATM PVC on the static ATM 1483 subinterface. In this example,
the VPI value is 1 and the VCI value is 101.
host1(config-subif)#atm pvc 201 1 101 aal0
Configure the static ATM interface. For example, the mpls-relay command
creates an ATM layer 2 services over MPLS tunnel on the circuit.
host1(config-subif)#mpls-relay 5.1.1.1 201
Create a bulk-configured VC range that includes the VPI and VCI values of the
previously configured ATM PVC. In this example, the VPI range (0–2) includes
VPI 1, and the VCI range (100–250) includes VCI 101.
host1(config)#interface atm 3/1
host1(config-if)#atm bulk-config test2 vc-range 0 2 100 250
Use to create a bulk-configured VC range on a static ATM AAL5 interface for use
by a dynamic ATM 1483 subinterface.
For detailed information about how to use this command, see "atm bulk-config"
on page 592.
Example
host1(config)#atm bulk-config test1 vc-range 0 1 101 600
vc-range 3 5 201 3200
Use the no version to remove the specified VC range from the ATM AAL5
interface, to remove the specified subranges from the specified VC range, or to
remove all subranges from the specified VC range. The no version also removes
any overriding profile assignments for ATM PVCs within the deleted VC range
or VC subrange.
See atm bulk-config.
Configuring ATM 1483 Dynamic Subinterfaces
607
Advertisement
Table of Contents
Troubleshooting
