Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 653

encapsulation vlan
interface fastEthernet
interface gigabitEthernet
interface tenGigabitEthernet
Chapter 16: Configuring Dynamic Interfaces Using Bulk Configuration
By default, all valid VLAN IDs and S-VLAN IDs are accepted.
Example
host1(config-if)#auto-configure vlan
Use the no version to terminate autodetection of the VLAN dynamic interface
type.
See auto-configure vlan.
Use to configure VLAN as the encapsulation method for the interface.
Example
host1(config-if)#encapsulation vlan
Use the no version to disable VLAN on an interface.
See encapsulation vlan.
Use to select a Fast Ethernet interface.
For information about specifying a Fast Ethernet interface, see "interface
fastEthernet" on page 623.
Example
host1(config)#interface fastEthernet 4/1
Use the no version to remove IP from an interface or a subinterface.
See interface fastEthernet.
Use to select a Gigabit Ethernet interface or a 10-Gigabit Ethernet interface.
To specify a Gigabit Ethernet interface for ERX7xx models, ERX14xx models,
and ERX310 router use the slot/port[.subinterface ] format.
To specify a Gigabit Ethernet interface or 10-Gigabit Ethernet interface for E120
and E320 routers, use the slot/adapter/port[.subinterface ] format.
For more information, see chapter Configuring Ethernet Interfaces in JUNOSe
Physical Layer Configuration Guide.
Examples
host1(config)#interface gigabitEthernet 1/0
host1(config)#interface gigabitEthernet 4/0/1
host1(config)#interface tenGigabitEthernet 4/0/1
Configuring VLAN Dynamic Subinterfaces
623