Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 13

For e series broadband services routers - link layer configuration
Hide thumbs Also See for JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010:
Table of Contents

Advertisement

Chapter 6
S-VLAN Oversubscription ............................................................................188
Monitoring VLAN and S-VLAN Subinterfaces ...............................................188
Using Ethernet show Commands ..........................................................191
802.3ad Link Aggregation for Ethernet Overview ........................................199
LACP .....................................................................................................200
Higher-Level Protocols ..........................................................................200
Load Balancing and QoS .......................................................................201
Ethernet Link Aggregation and MPLS ....................................................201
802.3ad Link Aggregation Platform Considerations .....................................201
Module Requirements ...........................................................................201
Interface Specifiers ...............................................................................202
802.3ad Link Aggregation References .........................................................202
Configuring 802.3ad Link Aggregation ........................................................202
Configuring an Ethernet Physical Interface ...........................................203
Configuring a LAG Bundle .....................................................................203
Configuring IP for a LAG Bundle ...........................................................204
Configuring a VLAN Subinterface for a LAG Bundle ...............................204
Configuring a PPPoE Subinterface for a LAG Bundle .............................204
Configuring MPLS for a LAG Bundle ......................................................205
Bundle ..................................................................................................209
Example: Configuring MPLS for a LAG Bundle .............................................209
Ethernet Link Redundancy Overview ..........................................................211
Ethernet Link Redundancy Configuration Models .................................211
Ethernet Link Redundancy Behavior ...........................................................215
Link Failure and Acquisition ..................................................................216
Protecting Against Physical Link Failure .........................................216
Protecting Against Virtual Link Failure ............................................216
Reverting After a Failover ...............................................................217
LACP Configuration and Member Link Behavior ...................................217
Member Link with Non-LAG Partner .....................................................218
Ethernet Link Redundancy and RSTP .............................................218
Acquiring Initial Links .....................................................................219
Detecting Failures ...........................................................................219
Failing Over ....................................................................................220
Configuring Ethernet Link Redundancy .......................................................220
Monitoring 802.3ad Link Aggregation .........................................................222
Table of Contents
199
xiii
Table of Contents

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.0.x

Table of Contents