Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 121

Interface types in lockout
Lockout state (seconds)
------------------------------- --- ---- ------- ------- ----
IP
BridgedEnet
PPP
PPPoE
Assigned profile (IP)
Assigned profile (BridgedEnet): beth
Assigned profile (PPP)
Assigned profile (PPPoE)
Assigned profile (any)
Interface Alias: atm20101
BridgedEnet subscriber info
Username: elaine@jpeterman.com
Password: putty
Authenticate: enabled
Assigned VC class
SNMP trap link-status: disabled
InPackets:
InBytes:
OutPackets:
OutBytes:
InErrors:
OutErrors:
InPacketDiscards:
InPacketsUnknownProtocol: 0
OutDiscards:
1 interface(s) found
Example 5 Displays the current state of a specific ATM subinterface created
on the PVC with the specified VPI and VCI values
host1#show atm subinterface atm 0/0/0/101
Interface ATM-Prot VCD VPI VCI
----------- -------- --- --- --- ------- ----- ---- ------ ---------
ATM 0/0.101 RFC-1483 101
Auto configure status
Auto configure interface(s)
Detected 1483 encapsulation
Detected dynamic interface
Interface types in lockout
Lockout state (seconds)
------------------------------- --- --- ------- ------- ----
PPPoE
Assigned profile (IP)
Assigned profile (BridgedEnet): none assigned
Assigned profile (PPP)
Assigned profile (PPPoE)
Assigned profile (any)
: IP
: Min Max Current Elapsed Next
1 30 16
900 3600 0
1 300 0
1 300 0
: ipoa
: ppptest
: pppoetest
: none assigned
:
: premium-subscriber-class
0
1904
0
0
0
0
14
0
Circuit
Type Encap MTU
0 101 PVC AUTO 9180 up
: dynamic
: PPPoE
: SNAP
: PPPoE
: none
: Min Max Current Elapsed Next
1 300 0
: none assigned
: none assigned
: pppoeprofile
: none assigned
Chapter 1: Configuring ATM
7 30
0 900
0 1
0 1
Interface
Status Type
Static
0 1
91
Monitoring ATM