Configuring Subscriber Policies - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual

JUNOSe 11.0.x Link Layer Configuration Guide
interface atm
interface fastEthernet
interface gigabitEthernet
interface tenGigabitEthernet

Configuring Subscriber Policies

To configure a nondefault client subscriber policy:
1.
430
Configuration Tasks
Use to select an ATM interface or subinterface type.
Example
host1(config)#interface atm 3/2.1
Use the no version to remove the interface or subinterface.
See interface atm.
Use to select a Fast Ethernet interface.
Example
host1(config)#interface fastEthernet 1/0.2
Use the no version to remove the interface or subinterface. You must issue the
no version from the highest level down; you cannot remove an interface or a
subinterface if the one above it still exists.
See interface fastEthernet.
Use to select a Gigabit Ethernet interface or a 10-Gigabit Ethernet interface.
Examples
host1(config)#interface gigabitEthernet 1/0
host1(config)#interface gigabitEthernet 4/0/1
host1(config)#interface tenGigabitEthernet 4/0/1
Use the no version to remove the interface or subinterface. You must issue the
no version from the highest level down; you cannot remove an interface or
subinterface if the one above it still exists.
See interface gigabitEthernet.
See interface tenGigabitEthernet.
From Global Configuration mode, create the subscriber policy and assign it an
alphanumeric name.
host1(config)#subscriber-policy client01
This command accesses Subscriber Policy Configuration mode.