Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 337

No baseline has been set
Interface statistics
packets
octets
errors
discards
1 mlppp interfaces found
Example 6 Displays status information about the specified MLPPP bundle
host1#show ppp interface mlppp group1 status
PPP interface mlppp group1 is up
1 mlppp interfaces found
Example 7 Shows complete configuration, statistics, and status information
about the specified MLPPP bundle
host1#show ppp interface mlppp group1 full
PPP interface mlppp group1 is up
Network interface administrative status is open
Configured network protocol is IPCP
IPCP protocol configuration
configured
administrative-status
ip-address
dns-precedence
wins-precedence
max-negotiations
IPCP protocol status
operational-status
IPCP negotiated options
ip-address
primary-dns-address
secondary-dns-address
primary-wins-address
secondary-wins-address
OSINLCP protocol configuration
configured
administrative-status
OSINLCP protocol status
operational-status
terminate-reason
PPP multilink member-interface serial 2/0:1/1 is up
Link interface administrative status is open
No baseline has been set
Interface statistics
packets
octets
errors
discards
LCP protocol configuration
max-receive-unit
authentication
magic-number
magic-number-mismatch
keepalive-timer
restart-timer
max-terminate
max-configure
Chapter 8: Configuring Multilink PPP
in out
0 0
50 0
0 0
0 0
true
open
1.2.3.4
local
local
10
up
local peer
1.2.3.4 6.7.8.9
none none
none none
none none
none none
false
open
not present
not configured
in out
0 0
1488 1972
0 0
0 0
use lower layer
none
enabled
ignore
30 seconds
3 seconds
2
10
Monitoring MLPPP
307