Configuring Individual Atm Pvc Parameters - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual

atm atm1483 export-subinterface-description
atm vp-description

Configuring Individual ATM PVC Parameters

As an alternative to using the atm pvc command to configure ATM PVC parameters
with a single command, you can access ATM VC Configuration mode to configure
individual ATM PVC parameters with separate commands, one parameter at a time.
You can configure parameters for the service category, encapsulation method, F5
OAM options, and Inverse ARP.
The following sections explain the benefits of using ATM VC Configuration mode and
describes how to configure the ATM VC mode :
Use the no version to remove the text description or alias.
See atm atm1483 description.
Use to export ATM 1483 VC interface descriptions to the line module. Descriptions
for ATM 1483 subinterfaces are configured with the atm atm1483 description
command.
The description can have up to 255 characters; however, when the description
is sent to the line module, it is truncated to 32 characters.
Example
host1(config)#atm atm1483 export-subinterface-description
Use the no version to restore the default behavior, in which ATM 1483 interface
descriptions are not exported to the line module.
See atm atm1483 export-subinterface-description.
Use to assign a text description to an individual VP on an ATM interface or
subinterface.
You must specify the VPI of the VP to which you want to assign the description.
The description string can be a maximum of 32 characters.
The VP description is stored in NVS and persists after a reboot.
Use the show atm vp-description command to display the text description.
Example
host1(config-if)#atm vp-description 2 vpi2Subscribers
Use the no version to restore the default value, a null string.
See atm vp-description.
Benefits on page 46
Creating Control PVCs on page 46
Creating Data PVCs on page 47
Chapter 1: Configuring ATM
Configuring Individual ATM PVC Parameters
45