Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 683

For e series broadband services routers - link layer configuration
Hide thumbs Also See for JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010:
Table of Contents

Advertisement

show profile
Chapter 16: Configuring Dynamic Interfaces Using Bulk Configuration
Use to display the source MAC address of a PPPoE client when a subscriber is
connected to the router through an available PPPoE session. You can then specify
this MAC address in "pppoe clear lockout interface" on page 502 to clear the
lockout condition for the PPPoE client.
To display configuration, status, and statistics information, including the source
MAC address of the PPPoE client, use the full keyword.
The following field descriptions and example include only the portion of the
show pppoe subinterface command display relevant to the source MAC address
for PPPoE clients. For more information about using this command, see "show
pppoe subinterface" on page 378 in "Configuring Point-to-Point Protocol over
Ethernet" on page 325.
Field descriptions
PPPoE subinterface Specifier for the PPPoE subinterface
source MAC address MAC address of the PPPoE client associated with the
dynamic PPPoE subinterface column
Example
host1#show pppoe subinterface full
...
PPPoE subinterface ATM 3/0.101 has source MAC address 0090.1a10.165e
...
See show pppoe subinterface.
Use to display information about profiles.
To display information about a specific profile, use the name keyword.
To display a list of profiles configured on the router, use the brief keyword.
Field descriptions
Profile Name of the profile that is displayed
IP address IP address and subnet mask of the interface, or none if the
interface is unnumbered
Unnumbered interface Specifier for the unnumbered interface, or none if
the interface is numbered
Router Name of the virtual router (VR) assigned to the profile; interfaces
created by the profile are attached to this VR
Directed Broadcast Enabled or disabled
ICMP Redirects Enabled or disabled
Access Route Addition Enabled or disabled
Network Address Translation Enabled or disabled; domain location (inside
or outside)
Monitoring Dynamic Interfaces and Profiles
653

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

Junose 11.0.x

Table of Contents