Platform Considerations; Module Requirements; Interface Specifiers - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual

Because the 4000 static ATM 1483 subinterfaces are already active, the router enables
only 4000 of the bulk-configured VCs to create dynamic ATM 1483 subinterface
columns and become active, yielding a combined total of 8000 active subinterfaces
on the line module. The router prevents the remaining 4000 inactive bulk-configured
VCs from connecting and becoming active until at least one subscriber connected
through an active ATM subinterface logs out, thereby making the associated
subinterface inactive and eligible for replacement.

Platform Considerations

You can configure dynamic interfaces on the following E Series Broadband Services
Routers:

Module Requirements

For information about the modules that support dynamic interfaces on ERX14xx
models, ERX7xx models, and the ERX310 router:
For information about the modules that support dynamic interfaces on the E120 and
E320 routers:

Interface Specifiers

The configuration task examples in this chapter use the slot/port[.subinterface ] format
to specify the physical interface that you want to configure to support dynamic
interfaces. However, the interface specifier format that you use depends on the router
that you are using.
Chapter 16: Configuring Dynamic Interfaces Using Bulk Configuration
E120 router
E320 router
ERX1440 router
ERX1410 router
ERX710 router
ERX705 router
ERX310 router
See ERX Module Guide, Table 1, Module Combinations for detailed module
specifications.
See ERX Module Guide, Appendix A, Module Protocol Support for information about
the modules that support dynamic interfaces.
See E120 and E320 Module Guide, Table 1, Modules and IOAs for detailed module
specifications.
See E120 and E320 Module Guide, Appendix A, IOA Protocol Support for information
about the modules that support dynamic interfaces.
Platform Considerations
577