Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 630

JUNOSe 11.0.x Link Layer Configuration Guide
profile atm1483 bulk-config-name pvc
shutdown
600
Configuring ATM 1483 Dynamic Subinterfaces
Example
host1(config-if)#profile atm1483 bulk-config-name test1 test1BaseProfile
Use the no version to remove the base profile assignment.
See profile atm1483 bulk-config-name.
Use to assign an overriding profile to a single ATM PVC that exists within a
bulk-configured VC subrange.
An overriding profile typically includes debugging attributes that help you
troubleshoot problems with the ATM 1483 dynamic subinterface column created
on the specified PVC.
The VPI and VCI values of the PVC you specify must exist between the starting
VPI/VCI values and ending VPI/VCI values of a VC subrange previously configured
with the atm bulk-config command.
Example 1 In this example, a previously configured VC range named test1
includes a VC subrange with VPIs 3–5 and VCIs 201–3200. The following
command assigns an overriding profile (test1DebugProfile) to the ATM PVC with
VPI 4 and VCI 301 that is within this subrange.
host1(config-if)#profile atm1483 bulk-config-name test1 pvc 4 301
test1DebugProfile
Example 2 Removes the overriding profile assignment from the ATM PVC with
VPI 4 and VCI 301, and restores the original base profile assignment
host1(config-if)#no profile atm1483 bulk-config-name test1 pvc 4 301
Use the no version to remove the overriding profile assignment for the PVC and
restore the original base profile assignment.
See profile atm1483 bulk-config-name pvc.
Use to disable an interface.
When you disable a dynamic ATM 1483 interface, the shutdown command
deletes the ATM 1483 dynamic subinterface column and removes the dynamic
ATM 1483 subinterface.
Example
host1(config-subif)#shutdown
Because the shutdown command removes the dynamic ATM 1483 subinterface
from the router, issuing a subsequent no version of this command has no effect;
that is, it does not restart the disabled subinterface.
See shutdown.