Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 112

JUNOSe 11.0.x Link Layer Configuration Guide
82
Monitoring ATM
RDI Circuit is in RDI state
VP Segment Oam State
not managed Circuit is in normal OAM state; no OAM fault conditions
AIS Circuit is in AIS state
RDI Circuit is in RDI state
InOamF4Cells Number of F4 OAM cells received
InOamF4CellsDropped Number of incoming F4 OAM cells that were
dropped
InOamF4EndLoopbackCells Total number of F4 end-to-end loopback cells
received on this interface, which is the sum of the following counts:
InOamF4EndLoopbackCommands Number of F4 end-to-end loopback
commands received
InOamF4EndLoopbackResponses Number of F4 end-to-end loopback
responses received
InOamF4SegLoopbackCells Total number of F4 segment loopback cells
received on this interface, which is the sum of the following counts:
InOamF4SegLoopbackCommands Number of F4 segment loopback
commands received
InOamF4SegLoopbackResponses Number of F4 segment loopback
responses received
InOamF4EndAisCells Number of F4 end-to-end AIS cells received
InOamF4SegAisCells Number of F4 segment AIS cells received
InOamF4EndRdiCells Number of F4 end-to-end RDI cells received
InOamF4SegRdiCells Number of F4 segment RDI cells received
InOamF4EndCCActDeActCells Number of F4 end-to-end activation or
deactivation CC cells received
InOamF4SegCCActDeActCells Number of F4 segment activation or
deactivation CC cells received
InOamF4EndCCCells Number of F4 end-to-end CC cells received
InOamF4SegCCCells Number of F4 segment CC cells received
OutOamF4Cells Number of F4 OAM cells sent
OutOamF4EndLoopbackCells Total number of F4 end-to-end loopback cells
sent on this interface, which is the sum of the following counts:
OutOamF4EndLoopbackCommands Number of F4 end-to-end loopback
commands sent