Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 146

JUNOSe 11.0.x Link Layer Configuration Guide
interface pos
interface serial
116
Configuring Frame Relay
Use to configure one of the local management interface types.
LMI provides configuration and status information relating to the virtual circuits
operating over Frame Relay.
LMI specifies polling mechanisms to receive incremental and full-status updates
from the network.
E Series routers conform to the following LMI specifications:
ansi ANSI T1.617 Annex D
q933a ITU-T Q.933 Annex A
cisco Original Group of Four specification developed by DEC, Northern
Telecom, Stratacom, and Cisco
none Suppresses LMI
The default is cisco.
Example
host1(config-if)#frame-relay lmi-type ansi
Use the no version to return to the default LMI type.
See frame-relay lmi-type.
Use to configure a POS interface in slot/port format:
slot Router chassis slot
port Line module port
Example
host1(config)#interface pos 0/1
Use the no version to remove the POS interface.
See interface pos.
Use to configure a serial interface in the appropriate format by selecting a
previously configured physical interface on which you want to configure Frame
Relay. For example, for a channelized T3 interface use
slot/port:channel/subchannel.
Use to configure a Frame Relay subinterface in the appropriate format by selecting
a previously configured physical interface. For example, for a T3-Frame interface
use slot/port.subinterface ; for a channelized T1/channelized E1 interface use
slot/port.channel-group.subinterface.