Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 193

show interfaces gigabitEthernet
show interfaces tenGigabitEthernet
Chapter 4: Configuring Upper-Layer Protocols over Static Ethernet Interfaces
Errors 0, Discards 0
Administrative qos-shaping-mode: none
Operational qos-shaping-mode: none
queue 0: traffic class control, bound to FastEthernet2/0
Queue length 0 bytes
Forwarded packets 1, bytes 46
Dropped committed packets 0, bytes 0
Dropped conformed packets 0, bytes 0
Dropped exceeded packets 0, bytes 0
See show interfaces.
Use to display the status of Gigabit Ethernet interfaces, 10-Gigabit Ethernet
interfaces, VLAN subinterfaces, or S-VLAN subinterfaces.
You can specify the following keywords:
delta Specifies that baselined statistics are to be shown
brief Displays the operational status of all configured interfaces
Field descriptions
GigabitEthernet or tenGigabitEthernet interfaceSpecifier Status of the
hardware on this interface
up Hardware is operational
down Hardware is not operational
Administrative status Operational state that you configured for this interface
up Interface is enabled
down Interface is disabled
Hardware Type of MAC device on this interface
Address MAC address of the processor on this interface
MAU Type of medium attachment unit (MAU) on the primary and secondary
physical ports:
SFP 1000BASE-LH, 1000BASE-SX, 1000BASE-ZX; for SFPs that are
empty, SFP (Empty) appears in this field; for SFPs that are installed in
the OC3-2 GE APS I/O module and do not have a Juniper Networks part
number programmed, SFP (GE Compliant) appears in this field
XFP 10GBASE-SR (10 Gbps), 10GBASE-LR (10 Gbps), 10GBASE-ER
(10 Gbps); for XFPs that are empty, XFP (Empty) appears in this field
MTU Size of the MTU for this interface
Operational Size of the largest packet processed
Administrative Setting for MTU size that you specified
Monitoring Upper-Level Protocols over Ethernet
163