Configuring S-Vlans Over Bridged Ethernet; Configuring S-Vlan Subinterfaces Over Bridged Ethernet - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual

JUNOSe 11.0.x Link Layer Configuration Guide

Configuring S-VLANs over Bridged Ethernet

S-VLANs over bridged Ethernet support the same set of higher-level protocols as
VLANs over bridged Ethernet. You configure S-VLANs over bridged Ethernet in the
same way that you configure VLANs over bridged Ethernet, with the addition of
certain commands.
Like VLANs, configuring S-VLANs over bridged Ethernet interfaces consists of two
basic tasks:
1.
2.
Before you can remove an S-VLAN subinterface, you must remove the upper-layer
interface stack.
NOTE: S-VLAN oversubscription is not supported on bridged Ethernet interfaces.
For more information about specifying ATM interfaces and subinterfaces, see Interface
Types and Specifiers in JUNOSe Command Reference Guide.

Configuring S-VLAN Subinterfaces over Bridged Ethernet

To configure an S-VLAN subinterface over bridged Ethernet:
1.
2.
3.
408
Configuring S-VLANs over Bridged Ethernet
Use the optional keyword untagged to specify that frames be sent untagged.
The keyword is valid only for VLAN ID 0. It allows tagged frames to be received,
but sends out untagged frames.
Example
host1(config-subif)#vlan id 400
There is no no version.
See vlan id.
Configure the layers up to and including the S-VLAN subinterface.
Configure the higher-level protocols above the S-VLAN subinterface.
Create an ATM 1483 subinterface and associated PVC.
host1(config)#interface atm 3/1.1
host1(config-subif)#atm pvc 1 5 33 aal5snap 0 0 0
Specify bridged Ethernet as the encapsulation method for the ATM 1483
subinterface.
host1(config-subif)#encapsulation bridge1483
Create a VLAN major interface by specifying VLAN as the encapsulation method
for the bridged Ethernet interface.
host1(config-subif)#encapsulation vlan