Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 677

Chapter 16: Configuring Dynamic Interfaces Using Bulk Configuration
Subscriber info Subscriber login information for the specified dynamic
interface type (bridged Ethernet or IP)
SNMP trap link-status Trap link status: enabled or disabled
InPackets Number of packets received on this interface
InBytes Number of bytes received on this interface
OutPackets Number of packets transmitted on this interface
OutBytes Number of bytes transmitted on this interface
InErrors Number of errors received on this interface
OutErrors Number of outgoing errors on this interface
InPacketDiscards Number of incoming packets discarded on this interface
InPacketsUnknownProtocol Number of incoming packets with an unknown
protocol type
OutDiscards Number of outgoing packets discarded on this interface
Example 1 Displays the current state of all ATM subinterfaces
host1#show atm subinterface
Interface ATM-Prot VCD VPI VCI Type Encap MTU
----------- -------- --- --- --- ----- ----- ---- ------------- ---------
ATM 2/0.101 RFC-1483 101
ATM 2/0.102 RFC-1483 102
ATM 2/0.103 RFC-1483 103
3 interface(s) found
Example 2 Displays summary information for all ATM subinterfaces shown in
Example 1
host1#show atm subinterface summary
3 subinterfaces: 1 up, 0 down,
1 dormant, 1 dormantLockout,
0 lowerLayerDown, 0 not present
Example 3 Displays status information for all ATM subinterfaces in the
dormantLockout state
host1#show atm subinterface status dormantLockout
Interface ATM-Prot VCD VPI VCI Type
----------- -------- --- --- --- ---- ---- ---- ----------- ---------
ATM 2/0.101 RFC-1483 101
1 interface(s) found
Example 4 Displays the current state of a specific ATM subinterface
host1#show atm subinterface atm 2/0.101
Circuit
Status
0 101 PVC AUTO 9180 dormantLockout Static
0 102 PVC AUTO 9180 up
0 103 PVC AUTO 9180 dormant
Circuit
Encap MTU Status
0 101 PVC AUTO 9180 dormantLockout Static
Circuit
Monitoring Dynamic Interfaces and Profiles
Interface
Type
Dynamic
Static
Interface
Type
Interface
647