Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 162

JUNOSe 11.0.x Link Layer Configuration Guide
show frame-relay summary
132
Monitoring Frame Relay
In discards: 0
In unknown protos: 0
See show frame-relay subinterface.
Use to scan all defined Frame Relay interfaces and circuits; reports aggregate
status as one of the following:
Up Traffic can flow on the interface
Down Traffic cannot flow because of a problem in the network
Unavailable Traffic cannot flow because hardware is unavailable
Example
host1#show frame-relay summary
28 interface(s) defined, 28 up, 0 down
840 sub-interface(s) defined, 840 up, 0 down
840 circuit(s) defined, 840 up, 0 down
See show frame-relay summary.
Out discards: 0