Configuring Dynamic Vlan Subinterfaces Based On Agent Circuit Identifier Information - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual

NOTE: For information about the maximum number of VLAN bulk configurations
supported per chassis, see JUNOSe Release Notes, Appendix A, System Maximums.
9.
10.

Configuring Dynamic VLAN Subinterfaces Based on Agent Circuit Identifier Information

The procedure you use to configure a dynamic VLAN subinterface that is based on
agent-circuit-identification information is similar to the procedure described in
"Configuring a Dynamic VLAN Subinterface" on page 617.
1.
2.
3.
4.
Chapter 16: Configuring Dynamic Interfaces Using Bulk Configuration
For example, the following command creates a VLAN range named myBulkConfig
made up of two VLAN subranges.
host1(config-if)#vlan bulk-config myBulkConfig vlan-range 0 100
vlan-range 110 200
Assign the base profile configured for the VLAN subinterface to the VLAN range
configured on the major VLAN interface.
host1(config-if)#profile vlan bulk-config myBulkConfig vlanBaseProfile
Configure the VLAN major interface to support autodetection of the VLAN dynamic
encapsulation type.
host1(config-if)#auto-configure vlan
Configure profiles containing characteristics for the dynamic upper-interface
encapsulation types to be created over the dynamic VLAN subinterface.
(Optional) If you want to create a nested profile assignment, create the profile
for an upper-interface encapsulation type, and include additional profile
characteristics for other encapsulation types as needed.
Create the base profile for the dynamic VLAN subinterface and enter Profile
Configuration mode by assigning the profile a name.
host1(config)#profile vlanMyBaseProfile
Define attributes for the VLAN subinterface in the base profile.
a. Enable autoconfiguration for the PPPoE upper-interface encapsulation type.
b. Enable autoconfiguration for the IP upper-interface encapsulation type.
c. Enable autoconfiguration of VLANs that are based on agent-circuit-identifier
information.
d. (Optional) Create nested profile assignments for the upper-interface
encapsulation types.
host1(config-profile)#vlan auto-configure pppoe
host1(config-profile)#vlan auto-configure ip
host1(config-profile)#vlan auto-configure agent-circuit-identifier
host1(config-profile)#exit
host1(config)#
Configuring VLAN Dynamic Subinterfaces
619