Configuring Dynamic Pppoe Over Static Pppoe With Ethernet Interface Columns - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual

To configure an ATM 1483 subinterface to support a dynamic PPPoE subinterface:
1.
2.
3.
4.
5.
6.
7.

Configuring Dynamic PPPoE over Static PPPoE with Ethernet Interface Columns

Figure 44 on page 486 shows dynamic PPPoE subinterface columns configured over
an Ethernet interface without VLANs.
Configure a physical interface.
host1(config)#interface atm 5/0
Configure an ATM 1483 subinterface.
host1(config-if)#interface atm 5/0.1
Configure a PVC by specifying the virtual circuit descriptor (VCD), the virtual
path identifier (VPI), the virtual channel identifier (VCI), and the encapsulation
type.
If you want the router to autodetect the encapsulation type, use the
aal5autoconfig option.
host1(config-subif)#atm pvc 10 100 22 aal5snap
host1(config-subif)#atm pvc 10 100 22 aal5autoconfig
Set the encapsulation type to PPPoE to create the PPPoE major interface.
host1(config-subif)#encapsulation pppoe
Assign a profile.
host1(config-subif)#pppoe profile pppoeProfile1
Configure the interface to detect and accept dynamic PPPoE subinterfaces.
host1(config-subif)#pppoe auto-configure
(Optional) Verify your configuration.
host1#show atm subinterface atm 5/0.1
host1#show pppoe interface atm 5/0.1
Configuring PPPoE Dynamic Interfaces over PPPoE Static Interfaces
Chapter 15: Configuring Dynamic Interfaces
485