Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 124

JUNOSe 11.0.x Link Layer Configuration Guide
show atm vc atm
94
Monitoring ATM
Interface VPI VCI
------------ --- ---- ---- ---- ----- ---- ----- ----- ----- ---
ATM 3/0.2 0 101
1 circuit(s) found that match the filter criteria
Example 5 Displays all reserved VC ranges on the router
host1#show atm vc reserved
Reserved VCC ranges:
Start Start End End
Interface VPI VCI
--------- ----- ----- --- ---
ATM 2/0 2 100
ATM 2/0 3 300
2 reservation(s) found
See show atm vc.
Use to display information about a specific VC.
To specify the circuit to display, do one of the following:
Enter the VCD.
Use the vpi-vci keyword and enter the VPI and VCI.
Enter the description configured for the ATM 1483 subinterface (with the
atm atm1483 description command) on which the VC resides.
Field descriptions
VCD Virtual circuit descriptor
VPI Virtual path identifier
VCI Virtual channel identifier
Encap Encapsulation method
Service Type Service type configured on the VC: UBR, UBR-PCR, NRT-VBR,
RT-VBR, CBR
Inverse ARP enable Whether or not Inverse ARP is enabled: yes, no
Assigned VC class Name of the VC class assigned to this VC, if configured
InPackets Number of packets received on this circuit
InBytes Number of bytes received on this circuit
InCells Number of ATM cells received on this circuit
OutPackets Number of packets transmitted on this circuit
OutBytes Number of bytes transmitted on this circuit
OutCells Number of ATM cells transmitted on this circuit
VCD Type Encap gory Peak
4375 PVC AUTO CBR 1000
VPI VCI
2 102
3 303
Avg Burst tus
0 0 UP