Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 111

show atm oam
ip 192.168.2.20 maps to VC 11 atm 2/0
ip 192.168.2.30 maps to VC 12 atm 2/0
See show atm map.
Use to display F4 OAM statistics for an ATM interface.
You must specify a VPI value in addition to the required ATM interface specifier.
You can use the following keywords.
segment Displays information about segment loopbacks
end-to-end Displays information about end-to-end loopbacks
To see F4 OAM circuits that are open, use the show atm vc command.
Field descriptions
Sending End To End Loopback Cells Enabled, disabled
Frequency Frequency configured on this circuit
End To End OAM CC verification Whether end-to-end CC verification is
enabled or disabled
OAM CC Type Whether the circuit is a sink or a source, or both a sink and
a source
OAM Current CC state
Ready OAM CC is not enabled
Active OAM CC cell flow is running
Activation Failed OAM CC activation failed
Wait Activate Waiting for interface to come up before the software
sends the activation request
Wait Activation Confirmation Waiting for activation confirmation from
the peer
Wait DeActivate Waiting for interface to come up before the software
sends the deactivation request
Wait DeActivation Confirmation Waiting for deactivation confirmation
from the peer
Segment OAM CC verification Whether segment CC verification is enabled
or disabled
VP State State of the VP: up, down
VP End To End Oam State
not managed Circuit is in normal OAM state; no OAM fault conditions
AIS Circuit is in AIS state
Chapter 1: Configuring ATM
broadcast
Monitoring ATM
81