Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 411

Chapter 10: Configuring Point-to-Point Protocol over Ethernet
Route Map Name Route map applied to the IP interface subscriber; enabled
or disabled
Auto Detect Router automatically detects packets that do not match any
entries in the demultiplexer table; enabled or disabled
Auto Configure Dynamic creation of subscriber interfaces on a primary IP
interface; enabled or disabled
IGMP Enabled or disabled
static-groups Displays address of any static groups configured for IGMP
Input policy Name of input policy and whether statistics are enabled or
disabled
Output policy Name of output policy and whether statistics are enabled or
disabled
PPP Keepalive PPP keepalive period, in seconds
PPP Magic Number Enabled or disabled
PPP Peer DNS Priority Enabled or disabled
PPP Peer WINS Priority Enabled or disabled
PPP Authentication Type of authentication configured: PAP, CHAP, or none
PPP Authentication Router Name of authentication virtual router
PPP Negotiate MRU MRU configured for the profile
PPP Packet Log Enabled or disabled
PPP State Log Enabled or disabled
PPP Chap Challenge Length Minimum and maximum Chap Challenge
length
PPP Passive Mode Enabled or disabled
PPP Multilink Enabled or disabled
PPP IPCP netmask option Enabled or disabled
PPP AAA Profile AAA profile associated with this PPP interface
PPP Multilink Fragmentation Enabled or disabled
PPP Multilink Fragment Size Multilink fragment size for this PPP interface
PPP Multilink Reassembly Enabled or disabled
PPP Multilink Mrru Multilink MRRU value for this PPP interface
PPP Initiate IP Initiation of IPv4 over this PPP interface; enabled or disabled
381
Monitoring PPPoE