Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 671

Chapter 16: Configuring Dynamic Interfaces Using Bulk Configuration
To display information for a particular VC range on a specified ATM AAL5
interface, use the command with the atm keyword and interface specifier and
the name keyword.
To display information only about overriding profile assignments configured for
specific ATM PVCs within bulk-configured VC subranges, use the command with
the override keyword. When you specify the override keyword, the command
does not display information about base profile assignments.
Field descriptions
Interface Identifier of the ATM AAL5 physical interface on which the
bulk-configured VC range resides. For more information about specifying
the ATM interface, see Interface Types and Specifiers in JUNOSe Command
Reference Guide.
Bulk Config Name Name of the bulk-configured VC range on this interface
Start VPI Starting virtual path identifier (inclusive) of the VC subrange
End VPI Ending virtual path identifier (inclusive) of the VC subrange
Start VCI Starting virtual circuit identifier (inclusive) of the VC subrange
End VCI Ending virtual circuit identifier (inclusive) of the VC subrange
Assigned Profile Base profile name for the dynamic ATM 1483 subinterface
assigned to this VC subrange with "profile atm1483 bulk-config-name" on
page 599 . When no profile is assigned to the VC subrange, the field displays
none assigned.
Admin State Administrative state of the VC subrange: up or down
Profile override(s) When overriding profile assignments are configured on
the router, the command displays the following fields:
Interface Identifier of the ATM AAL5 physical interface
Bulk Config Name Name of the bulk-configured VC range on this
interface that includes the VC subrange encompassing the specified ATM
PVC
VPI Virtual path identifier of the PVC within the bulk-configured VC
subrange
VCI Virtual circuit identifier of the PVC within the bulk-configured VC
subrange
Assigned Profile Name of the overriding profile assigned to the specified
PVC with "profile atm1483 bulk-config-name pvc" on page 600
Status Operational status of the overriding profile assignment: Active
or Inactive. Active indicates that the router uses the overriding profile
to create dynamic interface columns because no static ATM circuits with
the same VPI/VCI values exist on this interface. Inactive indicates that
the router does not use the overriding profile to create dynamic interface
columns because a static ATM circuit with the same VPI/VCI values exists
on this interface.
Monitoring Dynamic Interfaces and Profiles
641