Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 674

JUNOSe 11.0.x Link Layer Configuration Guide
644
Monitoring Dynamic Interfaces and Profiles
slot Number of the chassis slot
port Port number on the I/O module
subinterface Number of the subinterface in the range 1–2147483647
To specify an ATM subinterface for E120 and E320 routers, use the
slot/adapter/port.subinterface format.
slot Number of the chassis slot
adapter Identifier for the IOA within the E320 chassis, either 0 or 1, where:
0 indicates that the IOA is installed in the right IOA bay (E120 router)
or the upper IOA bay (E320 router).
1 indicates that the IOA is installed in the left IOA bay (E120 router) or
the lower IOA bay (E320 router).
port Port number on the IOA
subinterface Number of the subinterface in the range 1–2147483647
To display brief summary information for all ATM subinterfaces, or for ATM
subinterfaces configured on a specified ATM physical interface, use the summary
keyword.
To display status information only for ATM subinterfaces with a specific operating
status, use the status keyword with one of the following status values. (See the
Status field description for an explanation of these values.)
dormant
dormantLockout
down
lowerLayerDown
notPresent
up
To display the current state of an ATM subinterface created on the PVC with the
specified VPI and VCI values, use the atm slot/port/vpi/vci format (for ERX7xx
models, ERX14xx models, and ERX310 router) or the slot/adapter/port/vpi/vci
format (for E120 and E320 routers)1051/1052 (SLB) to identify the ATM
subinterface (Example 5).