Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 213

encapsulation vlan
ip address
pppoe
pppoe subinterface fastEthernet
pppoe subinterface gigabitEthernet
pppoe subinterface tenGigabitEthernet
svlan ethertype
Use to configure PPP as the encapsulation method for the interface.
Use the no version to remove PPP as the encapsulation method on the interface.
See encapsulation ppp.
Use to configure VLAN as the encapsulation method for the interface.
Use the no version to remove VLAN as the encapsulation method on the interface.
See encapsulation vlan.
Use to set a primary or secondary IP address for an interface or subinterface.
Specify the layer 2 encapsulation before you set the IP address.
Use the no version to remove an IP address or disable IP processing.
See ip address.
Use to configure PPPoE as the encapsulation method on the interface.
Use the no version to disable PPPoE on the interface.
See pppoe.
Use to create a PPPoE subinterface on a Fast Ethernet interface.
Use the no version to remove a PPPoE subinterface on a Fast Ethernet interface.
See pppoe subinterface.
Use to create a PPPoE subinterface on a Gigabit Ethernet interface or on a
10-Gigabit Ethernet interface.
Use the no version to remove a PPPoE subinterface on a Gigabit Ethernet interface
or on a 10-Gigabit Ethernet interface.
See pppoe subinterface.
Use to assign an Ethertype value for the S-VLAN subinterface.
Choose one of the following Ethertype values:
8100 Specifies Ethertype value 0x8100, as defined in IEEE Standard 802.1q
88a8 Specifies Ethertype value 0x88a8, as defined in draft IEEE Standard
802.1ad
Chapter 5: Configuring VLAN and S-VLAN Subinterfaces
Configuring an S-VLAN Subinterface
183