encapsulation pppoe
encapsulation vlan
interface atm
interface fastEthernet
aal5mux ip Specifies a VC multiplexed circuit. This option is used for IP
only.
Example
host1(config-subif)#atm pvc 6 0 11 aal5autoconfig
Use the no version to remove the specified PVC.
See atm pvc.
Use to configure PPPoE as the encapsulation method for the interface.
Example
host1(config-if)#encapsulation pppoe
Use the no version to remove PPPoE encapsulation from the interface.
See encapsulation pppoe.
Use to configure VLAN as the encapsulation method for the interface.
Example
host1(config-if)#encapsulation vlan
Use the no version to remove VLAN encapsulation from the interface.
See encapsulation vlan.
Use to select an ATM interface or ATM 1483 subinterface.
For information about specifying the ATM interface or subinterface, see "interface
atm" on page 482.
Examples
host1(config)#interface atm 5/0.1
host1(config)#interface atm 4/0/2.1
Use the no version to remove the interface or subinterface.
See interface atm.
Use to select a Fast Ethernet interface.
Example
host1(config)#interface fastEthernet 4/1
Configuring PPPoE Dynamic Interfaces over PPPoE Static Interfaces
Chapter 15: Configuring Dynamic Interfaces
495