Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 527

pppoe profile
svlan ethertype
svlan id
Use to assign a profile to a static PPPoE major interface. The profile configuration
is used to dynamically configure an upper bridged Ethernet, IP, PPP, or PPPoE
interface.
Specify a profile name with up to 80 alphanumeric characters.
The default encapsulation type, any, applies to any autoconfigured encapsulation
that does not have a specific profile assignment.
Examples
host1(config-subif)#pppoe profile pppoeProfile4
host1(config-if)#pppoe profile any anyProfile
Use the no version to remove the profile assignment from the interface.
See pppoe profile.
Use to assign an Ethertype value for the S-VLAN subinterface.
Choose one of the following Ethertype values:
8100 Specifies Ethertype value 0x8100, as defined in IEEE Standard 802.1q
9100 Specifies Ethertype value 0x9100, which is the default
9200 Specifies Ethertype value 0x9200
Use an Ethertype value that matches the Ethertype value set on the customer
premises equipment (CPE) to which your router connects.
Example
host1(config-if)#svlan ethertype 8100
Use the no version to restore the default value, 9100.
See svlan ethertype.
Use to assign S-VLAN IDs and VLAN IDs to VLAN subinterfaces.
Use S-VLAN ID and VLAN ID numbers that are in the range 0–4095 and that are
unique within the Ethernet interface.
Issue the svlan id command before any upper bindings are made, such as IP or
PPPoE.
Example
host1(config-if)#svlan id 4 255
There is no no version.
See svlan id.
Configuring PPPoE Dynamic Interfaces over PPPoE Static Interfaces
Chapter 15: Configuring Dynamic Interfaces
497