Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 710

JUNOSe 11.0.x Link Layer Configuration Guide
show ppp commands
show ppp interface ............................................251
show ppp interface mlppp..................................301
show ppp interface summary.....................251, 301
show pppoe commands
show pppoe interface..........................371, 556, 651
show pppoe interface lockout-time.............557, 652
show pppoe interface summary..........................373
show pppoe subinterface....................378, 558, 653
show pppoe subinterface summary....................378
show profile commands
show profile .......................................380, 558, 653
show radius commands
show radius override..........................................383
show radius remote-circuit-id-delimiter...............384
show radius remote-circuit-id-format..................384
show subscriber-policy command..............................440
show vlan commands
show vlan bulk-config.........................................653
show vlan subinterface.......................411, 565, 661
show vlan subinterface command..............................195
shutdown command..................................................118
dynamic interfaces.....................................600, 624
Frame Relay.......................................................116
POS....................................................................318
shutting down interfaces
dynamic ATM 1483............................................600
dynamic VLAN....................................................624
Frame Relay.......................................................116
POS....................................................................318
Simple Network Management Protocol. See SNMP
link status processing
SLARP (Serial Line Address Resolution Protocol)........455
Keep-Alive protocol.............................................455
keepalive interval................................................458
overview.............................................................455
See also Cisco HDLC
SMs (Service modules)
MLPPP features...................................................272
SNAP (subnetwork attachment point)........................169
SNMP (Simple Network Management Protocol) link
status processing....................................................118
snmp trap frame-relay link-status command..............118
SONET (Synchronous Optical Network)................30, 313
source, clock
ATM interfaces......................................................28
SSN LCP (short sequence number Link Control
Protocol) configuration option................................269
stacked virtual local area networks. See S-VLANs
stateful SRP switchover
and atm atm1483 subscriber command.............586
and subscriber command...................473, 506, 511
static interfaces..................................................466, 573
creating in VC subranges............................584, 606
creating in VLAN subranges................................636
static mapping, and NBMA interfaces..........................40
680
Index
subinterfaces
ATM 1483, dynamic...........................................578
ATM 1483, static.....................................................3
Frame Relay, monitoring....................................130
MLFR, monitoring...............................................150
VLAN, dynamic...................................................608
subnet mask
assigning to PPP interface...................................241
subnetwork attachment point. See SNAP
subranges, VC. See VC subranges
subscriber command.........468, 473, 506, 510, 545, 547
subscriber management, using for subscriber
authentication................................................473, 586
subscriber policies for transparent bridging...............420
configuring..........................................................430
defined...............................................................420
monitoring..........................................................440
See also subscriber policy commands
subscriber policy commands......................................440
arp......................................................................430
bridge subscriber-policy......................................430
broadcast............................................................430
ip........................................................................430
multicast.............................................................430
pppoe.................................................................430
relearn................................................................430
show subscriber-policy........................................440
subscriber-policy.................................................430
unicast................................................................430
unknown-destination..........................................430
unknown-protocol...............................................430
subscribers
authenticating on dynamic bridged Ethernet
interfaces........................................473, 511, 586
identifying for PPPoE..........................................329
support, technical See technical support
SVC (switched virtual circuit)
ATM........................................................................5
Frame Relay...............................................111, 119
svlan commands
svlan ethertype...........183, 186, 409, 496, 538, 625
svlan id...............................................................497
for S-VLAN tunnels.......................................186
for standard S-VLANs...........................183, 409
switch, 802.3ad.........................................................201
switched virtual circuit. See SVC
Synchronous Digital Hierarchy. See SDH
Synchronous Optical Network. See SONET
system
framing capabilities............................................227
system clock
selecting clock source...........................................28