Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 173

show frame-relay lip
host1#show frame-relay interface mlframe-relay members
Frame relay interface mlframe-relay TEST is up
Frame relay multilink member-interface 4/0:1 is up
Frame relay multilink member-interface 4/1:1 is up
See show frame-relay interface.
Use to display the state of MLFR Link Integrity Protocol (LIP) on an MLFR link.
Use the brief keyword to display the operational status of all configured interfaces.
Use the delta keyword to specify that baselined statistics are to be shown.
Field descriptions
Frame relay interface Specifier for the Frame Relay interface
Status of the major Frame Relay interface One of the following states:
Up—Traffic can flow on the interface
Offline—Traffic cannot flow because hardware is unavailable
Down—Traffic cannot flow because of a problem in the interface at the
current protocol layer
LowerLayerDown—Traffic cannot flow because of a problem in an
interface at a lower protocol layer
AdministrativelyDown—Traffic cannot flow because of manual
administrative intervention
Number of interface down transitions Number of interfaces that have
changed to a down state
Time since last status change Time since the interface last changed its state
Add Links sent Number of Add Link messages sent from this interface
Add Links received Number of Add Link messages received on this interface
Add Link Acknowledgments sent Number of Add Link acknowledgments
sent from this interface
Add Link Acknowledgments received Number of Add Link acknowledgments
received on this interface
Add Link Rejects sent Number of Add Link Reject messages sent from this
interface
Add Link Rejects received Number of Add Link Reject messages received
on this interface
Hellos sent Number of Hello messages sent from this interface
Hellos received Number of Hello messages received on this interface
Chapter 3: Configuring Multilink Frame Relay
Monitoring MLFR
143