Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 691

show vlan subinterface
Chapter 16: Configuring Dynamic Interfaces Using Bulk Configuration
dynamic interface columns because no static VLAN subinterfaces exist on
this interface. Inactive indicates that the router does not use the overriding
profile to create dynamic interface columns because a static VLAN
subinterface exists on this interface.
Example
host1#show vlan profile override
Profile override(s):
Bulk
Config Svlan Vlan Assigned
Interface Name
---------------- ------ ----- ---- --------- ------
FastEthernet 4/6 vlanB2
% 1 profile override(s) found
See show vlan profile.
Use to display configuration and status information for a specified VLAN
subinterface or for all VLAN subinterfaces configured on the router.
Use the summary keyword to display only the counts of all VLAN subinterfaces
and VLAN major interfaces configured on the router.
Use the vlan or svlan keywords to display information about specific VLAN IDs
or S-VLAN IDs.
Use the agent-circuit-identifier keyword to display information about VLAN
subinterfaces that are created based on the agent-circuit-id information in the
option 82 field of DHCP messages or in the DSL Forum VSA 26-1 of PPPoE PADR
and PADI packets. Using this keyword causes the router to display the
agent-circuit-identifier string in the command output.
Field descriptions
Interface Type and specifier of the VLAN subinterface
Status Status of the VLAN subinterface: up, down, dormant,
lowerLayerDown, absent
MTU Maximum allowable size (in bytes) of the MTU for the VLAN
subinterface
Svlan Id S-VLAN ID value, if configured
Vlan Id VLAN ID value for the VLAN subinterface
Ethertype S-VLAN Ethertype value, if configured
Type Type of VLAN subinterface
Static VLAN or S-VLAN subinterface was configured statically
Dynamic VLAN or S-VLAN subinterface was configured dynamically
Id Id Profile Status
---- 2 ipProfile Active
Monitoring Dynamic Interfaces and Profiles
661