Upper-Layer Protocols Over Static Ethernet Platform Considerations; Figure 8: Multiplexing Multiple Protocols Over A Single Physical Link - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual
For e series broadband services routers - link layer configuration
Hide thumbs
Also See for JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010:
- Configuration manual (788 pages)
Table of Contents
Advertisement
JUNOSe 11.0.x Link Layer Configuration Guide
Figure 8: Multiplexing Multiple Protocols over a Single Physical Link
ERX14xx models (rear view)
The following sections describe how to create the following common non-VLAN
configurations, which you can configure on Fast Ethernet, Gigabit Ethernet, and
10-Gigabit Ethernet interfaces:
NOTE: You can also configure upper-layer protocols over dynamic interfaces. See
"Configuring Dynamic Interfaces" on page 465 and "Configuring Dynamic Interfaces
Using Bulk Configuration" on page 573.
Upper-Layer Protocols over Static Ethernet Platform Considerations
You can configure upper-layer protocols over Ethernet on the following E Series
Broadband Services Routers:
154
Upper-Layer Protocols over Static Ethernet Platform Considerations
IP over Ethernet
PPPoE over Ethernet
IP over Ethernet and MPLS over Ethernet
IP over Ethernet, MPLS over Ethernet, and PPPoE over Ethernet
E120 router
E320 router
ERX1440 router
ERX1410 router
ERX710 router
ERX705 router
ERX310 router
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 and is the answer not in the manual?
Questions and answers