Monitoring Upper-Layer Dynamic Interfaces And Profiles - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual

JUNOSe 11.0.x Link Layer Configuration Guide
NOTE: For a list of vendor-specific attributes (VSAs) that apply to dynamic interfaces,
see JUNOSe Broadband Access Configuration Guide.

Monitoring Upper-Layer Dynamic Interfaces and Profiles

You can use the show commands described in this section to monitor configurations
created with dynamic interfaces and profiles.
NOTE: The E120 and E320 routers output for monitor and show commands is
identical to output from other E Series routers, except that the E120 and E320 routers
output also includes information about the adapter identifier in the interface specifier
(slot/adapter/port).
show atm aal5 interface
548
Monitoring Upper-Layer Dynamic Interfaces and Profiles
Use to display information about a configured ATM AAL5 interface.
Field descriptions
AAL5 Interface operational status Operational status of the AAL5 interface:
up, down, lowerLayerDown
time since last status change Time since last reported change to the AAL5
interface operational status in hh:mm:ss format
SNMP trap link-status Whether SNMP link status traps are enabled or
disabled on the ATM AAL5 interface
Auto configure ATM 1483 status Whether the autoconfiguration feature for
a dynamic ATM 1483 subinterface configured over the ATM AAL5 interface
is enabled or disabled
InPackets Number of packets received on this interface
InBytes Number of bytes received on this interface
OutPackets Number of packets transmitted on this interface
OutBytes Number of bytes transmitted on this interface
InErrors Number of incoming errors received on this interface
OutErrors Number of outgoing errors on this interface
InPacketDiscards Number of incoming packets discarded on this interface
OutDiscards Number of outgoing packets discarded on this interface
Example