Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 575

profile
subscriber
Example 2 Enables autodetection for the bridged Ethernet encapsulation type
using a nondefault lockout time range of 3600–21600 seconds (1–6 hours)
host1(config-subif)#auto-configure bridgedEthernet lockout-time 3600 21600
Example 3 Disables encapsulation type lockout for the IP encapsulation type
host1(config-subif)#auto-configure ip lockout-time none
Example 4 Either command reenables encapsulation type lockout for the IP
encapsulation type using the default lockout time range
host1(config-subif)#auto-configure ip
host1(config-subif)#no auto-configure ip lockout-time
Example 5 Permanently locks out the PPP encapsulation type until the
auto-configure ppp command is issued
host1(config-subif)#no auto-configure ppp
Use the no version to terminate detection of the specified encapsulation type
or, if the lockout-time keyword is specified, to restore the lockout time range
to its default value, 1–300 seconds.
See auto-configure.
Use to assign a profile to a static ATM 1483 or static PPP interface. The profile
configuration is used to dynamically configure an upper bridged Ethernet, IP,
PPP, or PPPoE interface.
The default encapsulation type, any, applies to any autoconfigured encapsulation
that does not have a specific profile assignment.
Example
host1(config-subif)#profile ip holland
Use the no version to remove the profile assignment from the interface.
See profile,
Use to configure a local subscriber on the router to support authentication and
configuration from RADIUS for a dynamic IPoA or bridged Ethernet interface.
For detailed information about how to use this command, see "subscriber" on
page 506.
Example
host1(config-subif)#subscriber ip user-prefix charlie domain myisp
password-prefix lucy
Use the no version to remove the subscriber.
See subscriber.
Chapter 15: Configuring Dynamic Interfaces
Configuring a Dynamic Interface from a Profile
545