Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 422

JUNOSe 11.0.x Link Layer Configuration Guide
encapsulation bridge1483
interface atm
392
Configuring Bridged IP
Use to configure bridged IP as the encapsulation method on an interface.
Use the unrestrictedProxyArp keyword to allow the router to perform
unrestricted processing of ARP requests even if the route is on the same interface
on which the request is received. See "Proxy ARP" on page 387 for details.
Example
host1(config-if)#encapsulation bridge1483
Use the no version to remove bridged IP as the encapsulation method on the
interface.
See encapsulation bridge1483.
Use to configure an ATM interface.
To specify an ATM interface for ERX7xx models, ERX14xx models, and ERX310
router, use the slot/port.[subinterface ] format.
slot Number of the chassis slot
port Port number on the I/O module
subinterface Number of the subinterface in the range 1–2147483647
To specify an ATM interface for E120 and E320 routers, use the
slot/adapter/port[.subinterface ] format.
slot Number of the chassis slot
adapter Identifier for the IOA within the E320 chassis, either 0 or 1, where:
0 indicates that the IOA is installed in the right IOA bay (E120 router)
or the upper IOA bay (E320 router).
1 indicates that the IOA is installed in the left IOA bay (E120 router) or
the lower IOA bay (E320 router).
port Port number on the IOA
subinterface Number of the subinterface in the range 1–2147483647
For more information, see "Creating a Basic Configuration" on page 22 in
"Configuring ATM" on page 3.
Examples
host1(config)#interface atm 3/1.20
host1(config)#interface atm 5/0/1.20
Use the no version to remove the ATM subinterface or the logical interface.
See interface atm.