Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 401

Use to display parameters on a PPPoE interface or a PPPoE subinterface.
If you do not specify an interface and subinterface, the router displays the PPPoE
interface and Status parameters for all configured interfaces.
If you specify an interface with no subinterface, the router displays the PPPoE
interface and Status parameters for that interface.
If you specify an interface and subinterface, the router displays detailed
parameters available for that subinterface.
Field descriptions
PPPoE interface Interface identifier. For more information about specifying
the physical interface, see Interface Types and Specifiers in JUNOSe Command
Reference Guide.
Status Operational status of the interface; possible values are:
operStatusUp Interface or subinterface is operational
Down Interface or subinterface is not operational
LowerLayerDown—Subinterface is not operational because an underlying
interface is down
full Displays configuration, status, and statistics information
max sessions Number of maximum allowable PPP sessions configured
mtu Maximum transfer unit (MTU) value; when derived from the PPPoE
MTU tag, the value can only be determined from an active session.
acName Name of PPPoE access concentrator
will not send ac info in PADS packet When the pppoe pads disable-ac-info
command is issued, indicates that the router does not send the AC-Name
and AC-Cookie tags in the PADS packet
duplicate-protection Whether duplicate protection is enabled or disabled
for the interface
capture remote circuit id Whether capture of the PPPoE remote circuit ID
sent from the DSLAM is enabled or disabled for the interface
active connections Number of live PPP connections
configured subinterfaces Number of PPPoE subinterfaces you configured
on an interface
Assigned profile Name of profile assigned to dynamic PPPoE interface
PPPoE Statistics Counters
PADI received/PADI transmitted Number of initiation control packets
received/transmitted
PADO received/PADO transmitted Number of offer control packets
received/transmitted
Chapter 10: Configuring Point-to-Point Protocol over Ethernet
Monitoring PPPoE
371