Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 692

JUNOSe 11.0.x Link Layer Configuration Guide
662
Monitoring Dynamic Interfaces and Profiles
Auto configure interface(s) Types of dynamic upper interfaces configured
with the auto-configure command: IP or PPPoE
Detected dynamic interface Type of dynamic upper interface detected
during autoconfiguration: IP, PPPoE, or (if no packet has been received)
none
Interface types in lockout Encapsulation types currently experiencing
lockout: IP, PPPoE, or none
Lockout state (seconds) Settings of encapsulation type lockout for the
upper-layer encapsulation type indicated
Min Minimum lockout time, in seconds
Max Maximum lockout time, in seconds
Current Current lockout time, in seconds; displays 0 (zero) if lockout
is not occurring
Elapsed Time elapsed into the lockout time, in seconds; displays 0
(zero) if lockout is not occurring
Next Lockout time for the router to use for the next lockout event, in
seconds
In Analysis of inbound traffic on this interface
Bytes Number of bytes received on the VLAN or S-VLAN subinterface
Packets Sum of all unicast, broadcast, and multicast packets received
on the VLAN or S-VLAN subinterface
Multicast Number of multicast packets received on the VLAN or S-VLAN
subinterface
Broadcast Number of broadcast packets received on the VLAN or
S-VLAN subinterface
Errors Total number of errors in all received packets; some packets
might contain more than one error
Discards Total number of discarded incoming packets
Out Analysis of outbound traffic on this interface
Bytes Number of bytes sent on the VLAN or S-VLAN subinterface
Packets Number of packets sent on the VLAN or S-VLAN subinterface
Multicast Number of multicast packets received on the VLAN or S-VLAN
subinterface
Broadcast Number of broadcast packets received on the VLAN or
S-VLAN subinterface