Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 132

JUNOSe 11.0.x Link Layer Configuration Guide
102
Monitoring ATM
OutPackets Number of packets transmitted
OutBytes Number of bytes transmitted
OutCells Number of ATM cells transmitted
InErrors Number of packets with errors received
OutErrors Number of packets not transmitted on this VP due to errors
InPacketDiscards Number of incoming packets discarded
InPacketUnknownProtocol Number of incoming packets with an unknown
protocol type
InByteDiscards Number of incoming bytes discarded
CrcErrors Number of CRC errors detected
SAR time-outs Number of segmentation and reassembly (SAR) timeouts
reached
Over-sized SDUs Number of oversized service data units (SDUs) received
The following fields appear only if F4 OAM is enabled on the VP:
Sending End to End Loopback Cells Enabled, Disabled
End to End OAM CC verification Enabled, Disabled
VP State State of the VP: up, down
VP Oam State OAM state of the VP: not managed (normal OAM state
with no OAM fault conditions), AIS, RDI
InOamF4EndCells Number of F4 end-to-end cells received
InOamF4EndCellsDropped Number of incoming F4 end-to-end cells
that were dropped
InOamF4EndLoopbackCells Number of F4 end-to-end loopback cells
received
InOamF4EndLoopbackCommands Number of F4 end-to-end loopback
commands received
InOamF4EndLoopbackResponses Number of F4 end-to-end loopback
responses received
InOamF4EndAisCells Number of F4 end-to-end AIS cells received
InOamF4EndRdiCells Number of F4 end-to-end RDI cells received
InOamF4EndCCActDeActCells Number of F4 end-to-end activation or
deactivation CC cells received
InOamF4EndCCCells Number of F4 end-to-end CC cells received
OutOamF4EndCells Number of F4 end-to-end CC cells transmitted