Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 463

multicast
pppoe
Use to modify the subscriber policy for MPLS to define whether a subscriber
(client) bridge interface permits (forwards) or denies (filters or drops) MPLS
packets.
Specify one of the following keywords:
permit Forwards packets of this type
deny Filters or drops packets of this type
MPLS packets are forwarded by default.
Example
host1(config-policy)#mpls deny
Use the no version to restore the default value.
See mpls.
Use to modify the subscriber policy for the multicast protocol to define whether
a subscriber (client) bridge interface permits (forwards) or denies (filters or drops)
multicast packets.
Specify one of the following keywords:
permit Forwards packets of this type
deny Filters or drops packets of this type
Multicast packets are forwarded by default.
Example
host1(config-policy)#multicast deny
Use the no version to restore the default value.
See multicast.
Use to modify the subscriber policy for PPPoE to define whether a subscriber
(client) bridge interface permits (forwards) or denies (filters or drops) PPPoE
packets.
Specify one of the following keywords:
permit Forwards packets of this type
deny Filters or drops packets of this type
PPPoE packets are forwarded by default.
Example
host1(config-policy)#pppoe deny
Chapter 13: Configuring Transparent Bridging
Configuration Tasks
433