Setting Optional Parameters - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual

JUNOSe 11.0.x Link Layer Configuration Guide
interface atm

Setting Optional Parameters

You can also set the following parameters:
24
Setting Optional Parameters
To enable VC integrity and generation of OAM F5 loopback cells on this circuit,
use the oam keyword.
Example
host1(config-if)#atm pvc 6 0 11 aal5snap cbr 10000
Use the no version to remove the specified PVC.
See atm pvc.
Use to configure an ATM interface or subinterface type.
To specify an ATM interface for ERX7xx models, ERX14xx models, and ERX310
router, use the slot/port.[subinterface ] format.
slot Number of the chassis slot
port Port number on the I/O module; on the OC3-2 GE APS I/O module,
you can specify ATM interfaces only in ports 0 and 1; port 2 is reserved for
a Gigabit Ethernet interface
subinterface Number of the subinterface in the range 1–2147483647
To specify an ATM interface for the E120 or E320 router, use the
slot/adapter/port[.subinterface ] format.
slot Number of the chassis slot
adapter Identifier for the IOA within the E320 chassis, either 0 or 1, where:
0 indicates that the IOA is installed in the right IOA bay (E120 router)
or the upper IOA bay (E320 router)
1 indicates that the IOA is installed in the left IOA bay (E120 router) or
the lower IOA bay (E320 router).
port Port number on the IOA
subinterface Number of the subinterface in the range 1–2147483647
Specify the type of interface or subinterface: point-to-point or multipoint.
Point-to-point is the default.
Examples
host1(config-if)#interface atm 0/1.20
host1(config-if)#interface atm 0/0/4.20
Use the no version to remove the subinterface or the logical interface.
See interface atm.