Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 559

l2tp policy
ppp aaa-profile
NOTE: Although an AAA profile and an interface profile have similar functionality,
they are not related and you need to treat them differently.
NOTE: For more information about AAA profiles, see JUNOSe Broadband Access
Configuration Guide.
ppp authentication
host1(config-profile)#ipv6 virtual-router westford01
Use the no version to remove the VR assignment from the profile. If no VR is
specified via RADIUS, then any subsequent use of the profile to create a dynamic
interface fails for lack of a VR.
See ipv6 virtual-router.
Use to assign a policy list to the ingress or egress of an interface to which the
profile is attached.
Example
host1(config-profile)#l2tp policy secondary-input my-policy
Use the no version to remove the association between a policy list and a profile.
See l2tp policy.
Use to assign an AAA profile to static and dynamic, multilink and nonmultilink
PPP interfaces.
The PPP application associates the AAA profile with the interface and passes the
AAA profile to AAA for authentication.
If an AAA profile is deleted after it has been assigned to an interface, AAA denies
the authentication and logs a message.
When you remove an AAA profile, it does not remove any corresponding bindings
between PPP interfaces or interface profiles and the AAA profile. If an AAA profile
with the same name is added, the interface cannot authenticate until the AAA
profile is reassigned.
Example
host1(config-profile)#ppp aaa-profile westford24
Use the no version to remove the AAA profile assignment.
See ppp aaa-profile.
Chapter 15: Configuring Dynamic Interfaces
Configuring a Dynamic Interface from a Profile
529