Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 686

JUNOSe 11.0.x Link Layer Configuration Guide
656
Monitoring Dynamic Interfaces and Profiles
aal5snap LLC encapsulated circuit; the LLC/SNAP header precedes the
protocol datagram
ATM1483 PVC service category Service type setting for the PVC configured
on a dynamic ATM 1483 subinterface: UBR (the default), UBR PCR, NRT-VBR,
RT-VBR, or CBR
ATM1483 PVC Peak rate Peak cell rate (PCR), in Kbps, for the PVC
configured on a dynamic ATM 1483 subinterfaces
ATM1483 PVC Avg rate Average rate, in Kbps, for the PVC configured on
a dynamic ATM 1483 subinterface; also referred to as sustained cell rate
(SCR)
ATM1483 PVC Burst size Length in cells of the burst for the PVC configured
on a a dynamic ATM 1483 subinterface; also referred to as maximum burst
size (MBS)
ATM1483 Description Text description assigned to ATM 1483 subinterfaces
that are created with this profile
ATM1483 Advisory Rx Speed Configured receive speed, in Kbps, for the
dynamic ATM 1483 subinterface. The E Series LAC sends this value to the
LNS in the RX Connect-Speed AVP [38].
ATM1483 PVC OAM Administrative status Status of OAM F5 loopback cell
generation (for VC integrity) on a circuit created with this profile: enabled
or disabled
ATM1483 PVC OAM Loopback frequency Number of seconds between
transmissions of OAM F5 end-to-end loopback cells on a circuit created with
this profile
ATM1483 Ip Subscriber information Subscriber login information for the
specified dynamic interface type
ATM1483 Profile Name of the profile assigned to the specified
upper-interface encapsulation type (bridged Ethernet, IP, PPP, or PPPoE);
these profiles are referenced in the base profile for a dynamic ATM 1483
subinterface as nested profile assignments
ATM Virtual Circuit Class Name of the ATM VC class assigned to the
bulk-configured VC ranges associated with this base profile, if configured
VLAN Auto-configure Whether autodetection of the specified upper-interface
encapsulation type (IP or PPPoE) is enabled or disabled for a dynamic VLAN
subinterface
VLAN Agent Circuit Identifier
subinterface uses the agent-circuit-identifier information in the option 82
field of DHCP messages or in the DSL Forum VSA 26-1 of PPPoE PADR and
PADI packets: enabled or disabled
VLAN Advisory Rx Speed Configured advisory receive speed, in Kbps, for
the dynamic VLAN subinterface; the E Series LAC sends this value to the
LNS in the RX Connect-Speed AVP [38]
Whether autodetection of the VLAN