Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 412

JUNOSe 11.0.x Link Layer Configuration Guide
382
Monitoring PPPoE
PPP Initiate IPv6 Initiation of IPv6 over this PPP interface; enabled or
disabled
PPPoE Max Sessions Maximum number of PPPoE subinterfaces that can
be on an interface
PPPoE Always-offer Router offers to set up a session for the client, even if
the router has insufficient resources to establish a session; enabled or disabled
PPPoE Remote-Circuit-Id The router captures and processes a
vendor-specific tag containing a remote circuit ID transmitted from a digital
subscriber line access multiplexer (DSLAM); enabled or disabled
PPPoE Log PPPoeControlPacket Enabled or disabled
PPPOE duplicate-protect Enabled or disabled
PPPoE ACNAME Access concentrator name
PPPoE URL URL sent in PADM message to PPPoE clients
PPPoE MOTM Message of the minute sent in the PADM message to PPPoE
clients
PPPoE Service-Name Table Name of the PPPoE service name table, if
configured for the specified profile
Example Displays configuration information for a PPPoE profile assigned to a
dynamic interface
host1#show profile name pppoeProfile
Profile
Unnumbered interface on
Router
Directed Broadcast
ICMP Redirects
Access Route Addition
Network Address Translation: Disabled
Source-Address Validation
Ignore DF Bit
Filter Option Packets
Administrative MTU
TCP MSS value
Inactivity Timer
Route Map Name
Auto Detect
Auto Configure
IGMP
static-groups
Input policy: bobb statistics enabled
Output policy: bobb statistics enabled
PPP Keepalive
PPP Magic Number
PPP Peer DNS Priority
PPP Peer WINS Priority
PPP Authentication
PPP Authentication Router
: pppoeProfile
: loopback 1
: default
: Disabled
: Disabled
: Enabled
: Disabled
: Disabled
: Disabled
: 1500
: 0
: Disabled
: Disabled
: Disabled
: Disabled
: Enabled
:
: 30
: enabled
: disabled
: disabled
: pap/chap
: