Creating Vlan Subranges That Include Static Vlan Subinterfaces - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual

To create a static VLAN subinterface within a VLAN subrange:
Create the VLAN major interface.
1.
host1(config)#interface gigabitEthernet 0/0
host1(config-if)#encapsulation vlan
Create a bulk-configured VLAN range that includes one or more VLAN subranges.
2.
host1(config-if)#vlan bulk-config test vlan-range 200 250
Create a static VLAN subinterface by adding a subinterface number to the
3.
interface identification command.
host1(config-if)#interface gigabitEthernet 0/0.2100
Do one of the following:
4.
Assign a VLAN ID for the subinterface.
host1(config-if)#vlan id 201
Assign a VLAN ID and the optional unique MAC address for the subinterface.
host1(config-if)#vlan id 201 mac-address 0090.1a01.1234
To fully configure the VLAN subinterface, assign an IP address, or make it
5.
unnumbered.
host1(config-if)#ip unnumbered loopback 0

Creating VLAN Subranges That Include Static VLAN Subinterfaces

You can configure a bulk-configured VLAN subrange that includes the VLAN ID
belonging to an existing VLAN on a static VLAN subinterface. This example is
essentially the reverse of the procedure in "Creating Static VLAN Subinterfaces Within
VLAN Subranges" on page 636.
To create a VLAN subrange that includes a static VLAN subinterface:
Create the VLAN major interface.
1.
host1(config)#interface gigabitEthernet 3/1
host1(config-if)#encapsulation vlan
Specify a static VLAN subinterface.
2.
host1(config-if)#interface gigabitEthernet 3/1.201
Do one of the following:
3.
Assign a VLAN ID for the subinterface.
host1(config-if)#vlan id 201
Assign a VLAN ID and the optional unique MAC address for the subinterface.
Chapter 16: Configuring Dynamic Interfaces Using Bulk Configuration
Configuring VLAN Dynamic Subinterfaces
637