Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 224

JUNOSe 11.0.x Link Layer Configuration Guide
194
Monitoring VLAN and S-VLAN Subinterfaces
Ethertype Ethertype assignment for the S-VLAN subinterface, 0x8100,
0x88a8, or 0x9100; 0x9100 is the default
In Analysis of inbound traffic on this interface
Bytes Number of bytes received on the VLAN or S-VLAN subinterface
Packets Sum of all unicast, broadcast, and multicast packets received
on the VLAN or S-VLAN subinterface
Multicast Number of multicast packets received on the VLAN or S-VLAN
subinterface
Broadcast Number of broadcast packets received on the VLAN or
S-VLAN subinterface
Errors Total number of errors in all received packets; some packets
might contain more than one error
Discards Total number of discarded incoming packets
Out Analysis of outbound traffic on this interface
Bytes Number of bytes sent on the VLAN or S-VLAN subinterface
Packets Number of packets sent on the VLAN or S-VLAN subinterface
Multicast Number of multicast packets sent on the VLAN or S-VLAN
subinterface
Broadcast Number of broadcast packets sent on the VLAN or S-VLAN
subinterface
Errors Total number of errors in all transmitted packets; some packets
might contain more than one error
Discards Total number of discarded outgoing packets
Example 1 Displays the status of a Gigabit Ethernet VLAN subinterface
host1:vr2#show interfaces gigabitEthernet 2/0.1
GigabitEthernet2/0.1 is Up, Administrative status is Up
VLAN ID: 10, address 0090.5e00.0001
In: Bytes 2357, Packets 23
Multicast 0, Broadcast 0
Errors 0, Discards 0
Out: Bytes 4872, Packets 57
Multicast 0, Broadcast 0
Errors 0, Discards 0
ARP Statistics:
In: ARP requests 0, ARP responses 0
Errors 0, Discards 0
Out: ARP requests 0, ARP responses 0
Errors 0, Discards 0
Example 2 Displays the status of a Gigabit Ethernet S-VLAN subinterface