Figure 18: Example Of Pppoe Over S-Vlan Stacking Configuration - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual
For e series broadband services routers - link layer configuration
Hide thumbs
Also See for JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010:
- Configuration manual (788 pages)
Table of Contents
Advertisement
JUNOSe 11.0.x Link Layer Configuration Guide
6.
7.
8.
9.
10.
Figure 18 on page 182 shows one S-VLAN subinterface with multiple PPPoE
subinterface stacks.
NOTE: Before you can remove an S-VLAN/VLAN subinterface, you must remove the
upper-layer interface stack.
Figure 18: Example of PPPoE over S-VLAN Stacking Configuration Procedure
encapsulation ppp
182
Configuring an S-VLAN Subinterface
Specify PPPoE as the encapsulation method on the interface.
host1(config-if)#pppoe
Create a PPPoE subinterface.
host1(config-if)#pppoe subinterface fastEthernet 4/1.1.1
Specify PPP as the encapsulation method on the interface.
host1(config-if)#encapsulation ppp
Assign an IP address and mask.
host1(config-if)#ip address 164.10.6.61 255.255.255.0
(Optional) Configure additional PPPoE subinterfaces by completing Steps 7
through 9 using unique numbering.
Advertisement
Table of Contents
Troubleshooting
