Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 558

JUNOSe 11.0.x Link Layer Configuration Guide
ipv6 policy
ipv6 sa-validate
ipv6 unnumbered
ipv6 virtual-router
528
Configuring a Dynamic Interface from a Profile
Use to suppress IPv6 router advertisement transmissions on a LAN local area
network (Ethernet) interface.
Example
host1(config-profile)#ipv6 nd suppress-ra
Use the no version to reenable the sending of IPv6 router advertisement
transmissions on the LAN (Ethernet) interface
See ipv6 nd suppress-ra.
Use to assign a policy list to the ingress or egress of an interface to which the
profile is attached.
Example
host1(config-profile)#ipv6 policy secondary-input my-policy
Use the no version to remove the association between a policy list and a profile.
See ipv6 policy
Use to enable source address validation on an IPv6 interface.
Source address validation verifies that a packet has been sent from a valid source
address.
Example
host1(config-profile)#ipv6 sa-validate
Use the no version to disable source address validation.
See ipv6 sa-validate.
Use to enable or disable IPv6 processing on an interface without assigning an
explicit IPv6 address to that interface.
Example
host1(config-profile)#ipv6 unnumbered loopback 0
Use the no version to remove the IPv6 address from the interface.
See ipv6 unnumbered.
Use to specify a VR in an IPv6 profile. Dynamic interfaces created with the profile
are assigned to this VR.
Example