Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 270

JUNOSe 11.0.x Link Layer Configuration Guide
interface atm
interface pos
240
Configuration Tasks
Use the no version to disable PPP on an interface.
See encapsulation ppp.
Use to specify a previously configured ATM interface on which you want to
configure PPP.
To specify an ATM interface for ERX7xx models, ERX14xx models, and ERX310
router, use the slot/port.[subinterface ] format.
slot Number of the chassis slot
port Port number on the I/O module
subinterface Number of the subinterface in the range 1–2147483647
To specify an ATM interface for E120 and E320 routers, use the
slot/adapter/port[.subinterface ] format.
slot Number of the chassis slot
adapter Identifier for the IOA within the E320 chassis, either 0 or 1, where:
0 indicates that the IOA is installed in the right IOA bay (E120 router)
or the upper IOA bay (E320 router).
1 indicates that the IOA is installed in the left IOA bay (E120 router) or
the lower IOA bay (E320 router).
port Port number on the IOA
subinterface Number of the subinterface in the range 1–2147483647
For more information, see "Creating a Basic Configuration" on page 22 in
"Configuring ATM" on page 3.
Examples
host1(config-if)#interface atm 9/1.1
host1(config-if)#interface atm 5/0/1.1
Use the no version to disable or remove the subinterface or the logical interface.
See interface atm.
Use to specify a previously configured packet over SONET (POS) interface on
which you want to configure PPP.
To specify a POS interface for ERX7xx models, ERX14xx models, and ERX310
router, use the slot/port.[subinterface ] format.
slot Number of the chassis slot
port Port number on the I/O module
subinterface Number of the subinterface