Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 679

show atm vc
Chapter 16: Configuring Dynamic Interfaces Using Bulk Configuration
Assigned profile (IP)
Assigned profile (BridgedEnet): none assigned
Assigned profile (PPP)
Assigned profile (PPPoE)
Assigned profile (any)
SNMP trap link-status: disabled
InPackets:
InBytes:
OutPackets:
OutBytes:
InErrors:
OutErrors:
InPacketDiscards:
InPacketsUnknownProtocol: 0
OutDiscards:
1 interface(s) found
See show atm subinterface.
Use to display a summary of all configured ATM VCs and reserved VC ranges.
You can specify one or more of the following keywords individually or in
combination:
vpi Displays VCs on a specific VPI
category Displays VCs that have a specific service category
status Displays VCs with a certain status
To display only a summary of all reserved VC ranges on the router, specify the
reserved keyword with no other keywords. This includes VPI/VCI ranges reserved
for use by dynamic ATM 1483 subinterfaces.
Field descriptions
Interface Interface identifier
VPI Virtual path identifier
VCI Virtual channel identifier
VCD Virtual circuit descriptor
Type Type of circuit: PVC
Encap Encapsulation method: AUTO, AAL5, MUX, SNAP, ILMI, F4-OAM
Category Service type configured on the VC: UBR, UBR-PCR, NRT-VBR,
RT-VBR, or CBR
Rx/Tx Peak Peak rate, in Kbps
Rx/Tx Avg Average rate, in Kbps
: none assigned
: none assigned
: pppoeprofile
: none assigned
5119
358672
5107
357510
0
0
3
0
Monitoring Dynamic Interfaces and Profiles
649