Interface Specifiers; 802.3Ad Link Aggregation References; Configuring 802.3Ad Link Aggregation - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual

JUNOSe 11.0.x Link Layer Configuration Guide
For information about the modules that support 802.3ad link aggregation on the
E120 and E320 routers:

Interface Specifiers

The configuration task examples in this chapter use the format for ERX7xx models,
ERX14xx models, and the ERX310 router to specify 802.3ad link aggregation.
For example, the following command specifies a Gigabit Ethernet interface on port
0 of an I/O module in slot 4.
When you configure a Gigabit Ethernet interface or a 10-Gigabit Ethernet interface
on E120 or E320 routers, you must include the adapter identifier as part of the
interface specifier. For example, the following command specifies a Gigabit Ethernet
interface on port 0 of the IOA installed in the upper adapter bay of slot 3.
For more information about interface types and specifiers on E Series models, see
Interface Types and Specifiers in JUNOSe Command Reference Guide.

802.3ad Link Aggregation References

For more information about 802.3ad link aggregation implementations, consult the
following resources:

Configuring 802.3ad Link Aggregation

To configure link aggregation on Ethernet interfaces, you must configure the Ethernet
interface, create the LAG bundle, and add the Ethernet interface as a member link
in the LAG bundle. Optionally, you can then configure IP, a VLAN subinterface, a
PPPoE subinterface, or MPLS for the LAG bundle.
For more information about specifying LAG interfaces and subinterfaces on E Series
routers, see Interface Types and Specifiers in JUNOSe Command Reference Guide.
Tasks to configure 802.3ad link aggregation interfaces are:
202

802.3ad Link Aggregation References

See E120 and E320 Module Guide, Table 1, Modules and IOAs for detailed module
specifications.
See E120 and E320 Module Guide, Appendix A, IOA Protocol Support for information
about the modules that support 802.3ad link aggregation.
host1(config)#interface gigabitEthernet 4/0
host1(config)#interface gigabitEthernet 3/0/0
IEEE 802.1w (Rapid Reconfiguration of Spanning Tree)
IEEE 802.3ad (Link Aggregation)
"Configuring an Ethernet Physical Interface" on page 203
"Configuring a LAG Bundle" on page 203