Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 225

show vlan subinterface
host1:vr2#show interfaces gigabitEthernet 2/0.2
GigabitEthernet2/0.2 is Up, Administrative status is Up
SVLAN ID: 10, VLAN ID: 100, Ethertype 0x9100
In: Bytes 2357, Packets 23
Multicast 0, Broadcast 0
Errors 0, Discards 0
Out: Bytes 4872, Packets 57
Multicast 0, Broadcast 57
ARP Statistics:
In: ARP requests 0, ARP responses 0
Errors 0, Discards 0
Out: ARP requests 0, ARP responses 0
Errors 0, Discards 0
See show interfaces.
Use to display configuration and status information for a specified VLAN
subinterface or for all VLAN subinterfaces configured on the router.
Use the summary keyword to display only the counts of all VLAN subinterfaces
and VLAN major interfaces configured on the router.
Use the mac-address keyword to display information about the VLAN
subinterfaces that were configured with unique MAC addresses.
Use the vlan or svlan keywords to display information about specific S-VLAN
IDs or VLAN IDs.
Field descriptions
Interface Type and specifier of the VLAN subinterface
Status Status of the VLAN subinterface: up, down, dormant,
lowerLayerDown, absent
MTU Maximum allowable size (in bytes) of the maximum transmission
unit (MTU) for the VLAN subinterface
Svlan Id S-VLAN ID value, if configured
Vlan Id VLAN ID value for the VLAN subinterface
Ethertype S-VLAN Ethertype value, if configured
Type Type of VLAN subinterface
Static VLAN or S-VLAN subinterface was configured statically
Dynamic VLAN or S-VLAN subinterface was configured dynamically
In Analysis of inbound traffic on this interface
Bytes Number of bytes received on the VLAN or S-VLAN subinterface
Packets Sum of all unicast, broadcast, and multicast packets received
on the VLAN or S-VLAN subinterface
Chapter 5: Configuring VLAN and S-VLAN Subinterfaces
Monitoring VLAN and S-VLAN Subinterfaces
195